Forums » Off-Topic Discussions

Dry Screw Vacuum Pump Working Principle

    • 3271 posts
    July 24, 2023 2:25 AM EDT

    Dry Screw Vacuum Pump Working Principle

    Dry vacuum pump technology – especially variable pitch screw chemical dry pumps – offer clear, measurable advantages in a wide variety of essential applications. A properly designed dry screw vacuum pump ensures the processing needs are accomplished with a safe, reliable, and cost-effective solution.Get more news about 2022 Dry Screw Vacuum Pump,you can vist our website!

    Dry screw vacuum pumps require no water or oil for sealing or lubrication in the vacuum stages. Consequently, these dry vacuum systems eliminate effluent generation, pollution, and high treatment costs.
    A dry screw vacuum pump consists of two parallel, non-contacting helical screw-shaped rotors (1) and (2), Fig. 1, rotating synchronously at high speeds via precision gears (3). They rotate in opposite directions, and in so doing, trap a quantity of gas at the inlet (5) and transport it towards the exhaust port (6) and into the exhaust channel (7). The walls of the stator (9) and the special shape of the intermeshing screws form the compression chambers or pockets (4) that transport the gas.
    Small clearances between the screws and the stator, as well as small clearances between the intermeshing screws, ensure that the amount of reverse leakage towards the inlet is small in comparison to the forward flow of gas generated by the screw pockets.
    Reverse flow of the pumped gases is prevented by the length of the sealing boundary, (i.e., the number of spirals and tight clearances). On pumps fitted with a compression plate a slight reverse expansion of gas into the screws occurs when the outlet valve or port is first exposed. This is quickly expelled as the trapped volume is progressively reduced to zero by the action of the screws.
    The reverse flow of gas is primarily controlled by the width of the “sealing lands” on the tips of the screw profile. These wide lands run in close proximity with the stator and minimize the reverse leakage of gas. Ultimate pressures in screw pumps can be less than 0.01 torr (0.01 mBar).
    In variable pitch models, the gas is compressed as the pitch changes to give additional compression before the pump exhaust. This spreads the heat load more evenly across the length of the rotors. In single pitch models, more compression is achieved in the last half-turn against a compression plate or valve, biasing the heat generation towards the exhaust. In dry pumps, temperatures have to be high enough to avoid condensation throughout and low enough to avoid auto-ignition and polymerization. Progressively higher gas temperature towards the exhaust in variable pitch pumps assists greatly in preventing condensation of pumped vapors. Variable pitch screw pumps also use power more efficiently than single pitch ones.
    Cooling is achieved via the surrounding jacket (8). Pumps can be configured for direct or indirect closed-loop cooling. There are many advantages with the latter, as it means the plant’s cooling water is never in direct contact with the pump material and the jacket cannot silt up or corrode due to poor cooling water quality.
    A gas ballast port (10) is available. If required, a gas ballast can help to warm-up a cold pump or dry a wet pump faster, take a flammable vapor out of its flammable range and help to clean solids out of a pump, particularly during solvent flushing.