The Choice Of China Stud Supplier Products

• Posted by weigao fasteners July 20, 2021 - Filed in Business - #Hexagon Socket Head Bolt  #China Stud Supplier  - 479 views

  The Occupational Safety and Health Administration (OSHA) stipulates that rigging and lifting equipment should be “checked before each shift, and checked as needed during use to ensure their safety.” If Hexagon Socket Head Bolt is found If it is defective, stop using it immediately.

  Don't paint eye bolts
  If the eye bolts are covered by paint, the eye bolts cannot be inspected. The paint hides signs of wear and damage. If you are concerned about corrosion, please choose stainless steel eye bolts or eye bolts with a corrosion-resistant surface.

  Do not use worn or damaged eye bolts
  Wear and damage of any components will significantly reduce the load capacity of the eye bolts. Damaged eye bolts are more likely to deform, bend or break. They should be discontinued and replaced immediately.

  Do not process or modify the eye bolts
  The working load limit of the eye bolt is determined by its design. Modifications such as shortening the handle or removing material from the eyelet or shoulder will significantly reduce its load limit and increase the risk of failure.

  Safe lifting with eye bolts
  Practices to be avoided when using eye bolts:

  Run the sling by the eye bolt
  It is usually convenient to pass a sling through a pair of eye bolts, but this should be avoided. Connecting the sling in this way will exert an angular force on the eye bolt. As we mentioned before, the angular force will greatly reduce the WLL of the eye bolt.

  Use a sling with eye bolts
  Do not force lifting and rigging equipment into your eyes
  Equipment such as handcuffs and slings should move freely in the eyes. If the fit is too tight, the lifting may exert excessive force, which may deform or break the eye.

  Don't let the load spin
  Connecting the load to a single eye bolt allows the load to rotate freely. This is dangerous. Torsion can damage eyes and accessories. They may also cause accessories or equipment to fall off the eye bolts. In addition, the freely rotating load poses a danger to the equipment and personnel involved in the lifting operation. If the lift requires the load to rotate, be sure to use the slogan (guide wire or guide wire), but you must be extra careful near power lines or in an overhead environment, because the slogan will conduct electricity!

  Do not connect the hook directly to the eye bolt
  The hook shall be connected to the eye bolt by a shackle. This is especially important if only the tip of the hook fits the eyes. If the hook does not fully enter the eye, the strongest point of the hook will not support the load. Use a suitable lifting shackle whose pin fits your eyes, and use a crown that has enough space to fully insert the hook.

  China Stud Supplier Do not impact the eye bolts
  The lift should be completed slowly and gradually. The sudden acceleration of the load or the sudden change of the load direction will cause the load tension of the rigging equipment to increase greatly. Due to the increase in load tension generated by the impact load, the eye bolts may fail.