Forums » News and Announcements
The steps of plywood film coating
-
Film-faced plywood is the special kind with two sides coated with a wearable and waterproof film. Other names are shuttering plywood, formwork plywood, concrete formwork. Film faced plywoods have been widely using in most of the construction due to their special water proof, holding capacity and could be reused for many times.To get more news about commercial plywood, you can visit boosterplywood.com official website.
Film-faced plywood is a common formwork used in construction works by many prominent features such as light weight, easy assembly, good quality concrete surface. , the number of re-use is high, ...
Scaffolding should be placed on a flat, firm surface. Set foot on wooden beams flat and click to the correct height according to technical requirements.
The main beam has a force, located on the top of the letter 'U' of scaffolding, the ideal bar spacing is 600mm - 620mm.
Secondary beams are also secondary support bars, associated with the formwork battens by screws. The spacing between the side beams should not exceed 40mm, depending on the plywood thickness and concrete thickness. Composite panels, if cut to suit the actual application conditions, must be painted or waterproof at the cutting heads.
Joining planks together, sticking tape along the graft. For easier molding after application, apply a layer of oil to the desired surface. Be careful not to sweep too much oil because it will be difficult to coat the waterproof coat after repainting.