Forums » Off-Topic Discussions

• freeamfva jack

  

  • 3280 posts
   

  June 2, 2023 11:12 PM EDT

  0975AT Sensor Network Termination Cable & Termination Resistor

  A 0975AT Sensor Network Termination Cable should be used to connect the last sensor on the network to improve communication reliability.Get more news about Super fine peek Sensor Cable,you can vist our website!

  RS485 best practice requires a termination resistor to be placed at each end of a network. The 0975AT cable has a built-in 120 Ω resistor. Another 120Ω termination resistor is supplied with the 0975AT cable, this should be installed at the RS485 Master end of the network.
  Alongside their use in data transmission, optical fibers can also be used for measuring temperature, light, breakage, expansion, pressure, and oscillation. This functionality offers effective monitoring of buildings or other properties, e.g. for the early detection and localization of fires.

  Thanks to the rust-free flexible metallic protective sleeve, the IP67-rated sensor cable is protected against mechanical influences from outside. The KIAG 10-32 pos. connecting plug with a hexagonal swivel nut ensures IP67 protection. The sturdy connecting cable is available in various designs. In addition to standard lengths, customer-specific special lengths can also be provided. On the amplifier side, connection variant KIAG 10-32 pos. or BNC pos. can be selected.

  If there is only one sensor on the network, then an 0975AT cable should be used.
  Only one 0975AT cable should be used on a network.
  A 120Ω resistor must also be placed at the RS485 Master end of the network.
  All other sensors must remain unterminated using a 0975A Sensor Cable.